|
|
FAQs
02.01.2006
Netlimiter 2 shows this problem: "Couldnt connect to Netlimiter service".
- You've installed the NetLimiter2 and tryied to start it without reboot. You have to reboot your computer after installation.
- NetLimiter 2 installation might be corrupted - try to reinstall it.
- NetLimiter 2 service is manually switched off. Only system admnistrators can switch it off, so if you don't have administrator right, contact him. If you are the admin, then try following procedure to switch it on:
-
Run Windows command line - START->Run - type cmd - click on OK
-
Type command: 'net start nlsvc' and press Enter. (Now you should see message that it was successfully started.)
|
www.NetLimiter.com